Wera 9710 Foam Insert Screwdriver Set 1, 18 Pieces
The toolbox drawer test: open it and immediately see what is missing. The 9710 packs sixteen Wera screwdrivers and two screw grippers into a two-tone foam insert where every tool has a contour-cut home. Pull one out and the light grey lower layer shows through, so a missing driver announces itself at a glance. The foam is chemical-vapour-free, water- and oil-repellent, and sized for the Tool Rebel roller cabinet if your shop runs one.
The mix inside reads like a working journeyman wheel spoke: two 932 A Chiseldrivers for striking, chiselling, and coaxing seized fasteners with a wrench on their hex bolsters; eight Kraftform Plus drivers in slotted, Phillips, and Pozidriv with Lasertip biting tips for secure grip at low contact pressure; two micro Kraftform drivers for electronics and fine work; two 160i VDE insulated drivers tested at 10,000 V for electrical trades; two screw grippers for awkward long-reach fasteners; and two stubbies for engine bay, cabinet, and carburetor clearance. It is a toolbox move-in ready for automotive, aviation, marine, machinery, and industrial service.
What is in the set
932 A slotted Chiseldriver: 1.0 x 5.5 x 100mm, 1.2 x 7 x 125mm
350 PH Phillips screwdriver: PH 1 x 80mm, PH 2 x 100mm, PH 3 x 150mm
350 PH Stubby/carburetor: PH 2 x 25mm
355 PZ Pozidriv screwdriver: PZ 1 x 80mm, PZ 2 x 100mm
335 slotted screwdriver: 0.8 x 4 x 100mm, 1.0 x 5.5 x 125mm
334 slotted screwdriver: 1.2 x 6.5 x 150mm
335 Stubby/carburetor: 1.0 x 5.5 x 24.5mm
2050 PH micro: PH 0 x 40mm
2035 slotted micro: 0.4 x 2.5 x 80mm
160i VDE slotted: 0.4 x 2.5 x 80mm, 0.6 x 3.5 x 100mm
